Jastech EMC Consulting LLC

Automotive Electronic Design Techniques and Analysis Required to Meet EMC Requirements

 

May 16&17, 2013

 

INTRODUCTION

 EMC terminology

 Electromagnetic noise source

 

CABLING  

 Electric filed coupling

 Magnetic field coupling

 Cable configurations

 

GROUNDING PRINCIPLES    

 Single-point ground system

 Multi-point ground system

 Hybrid ground system

 Galvanic action

 Galvanic series

 

COMPONENTS USED IN AUTOMOTIVE    

 Capacitors

 Inductors

 Transformers

 Resistors

 Ferrite beads

 Diodes

 Relays - transient suppression for inductive loads

 

ANTENNAS IN EMC    

 Antenna types

 Radiation due to accelerated charges

 Electric-field source and wave

 Magnetic-field source and wave

 Wavelength

 

DIGITAL CIRCUIT DESIGN  

 Noise sources

 PCB layout

 Power distribution

 Ground grids / ground planes

 Decoupling capacitors

 Analog versus digital circuits

 Noise voltage objectives

 

DIGITAL CIRCUIT ANALYSIS   

 Differential mode noise

 Common mode noise

 Predicting and controlling radiation

 

SHIELDING

 Shielding effectiveness

 Absorption loss

 Reflection loss

 Apertures

Trade-off of different shielding materials

 

ELECTROSTATIC DISCHARGE

 Human body model

 Static discharge waveform

 Chip protection

 Circuit board level protection

  

Cost

$1,195

 

Register by April 1 for a $200 saving ($995)

LOCATION:

CROWNE PLAZA

27000 South Karevich Drive

Novi, Michigan 48377

 

REGISTRATION AND FEE INFORMATION:

The registration fee includes a course workbook, lunch, and refreshments.     Class size is limited, so please register early.  If you must cancel your registration, a refund can be made only if we receive notice of withdrawal at least 10 days prior to class start.  Jastech EMC Consulting, LLC reserve the right to cancel course if there are an insufficient number of registrants by the cancellation deadline.  In such an event, the registration fee will be refunded in full.

To register for this course, please complete the following two steps.

1. Send an email to reg@Jastech-EMC.com containing the information listed below.

Name of course:  Automotive Electronic Design Techniques and Analysis Required to Meet EMC Requirements
Name:
Address:
Phone:
Email address:
Organization:

2. Submit payment by credit card, purchase order or check, as described below.

To pay by credit card through PayPal, click the button shown.

Training May 16&17, 2013

 

Automotive Electronic Design Techniques and Analysis Required to Meet EMC Requirements

(Novi, Michigan  May  16-17 2013)

  $995 (Early registration) , $1195 (after April 1)

To email a purchase order, scan and send to the following email address reg@Jastech-EMC.com. To mail a check or purchase order, make it out Jastech EMC Consult,LLC and mail to the following address.

Jastech EMC Consulting,LLC

PO Box 3332

Farmington Hills, MI 48333

Phone: 248-876-4810

HOME